Edge milling cutter KF 3 – unique manual milling cutter for double-sided milling of glued components
STA 80 – Stationary table including rotary disk with chopping device
Edge chopping device KKG 30 – for straight workpieces and mouldings
To cut off edge bands made of plastic or veneer. For flush and right-angled edges of protruding beginnings or end pieces or joint edges.
Ideal to be used for edge banding and edge milling even on large workpieces
Vacuum clamping device VS 2 For direct assembly on the working table surface
Vacuum clamping device VS 1. Easy assembly and disassembly of the vacuum clamping device on a worktable by means of a handy lever screw
Hand gluer for glueing large surfaces using vinyl glue (White). Lower roller width: 122 mm. Equipped with trigger shut-off device to stop the flow of glue. Also comes with a support where it can be left when not in use, thus keeping the working area and the machine clean. Moreover, is equipped with an upper auxiliary roller for clean glueing of strips.
Cuts both sides simultaneously. Double edge trimmer. Cuts both sides simultaneously. For edges up to 40 mm. For larger edges it can be used as two independent edge trimmers. Top quality long life blades which are easy to replace once worn.
Clean and high quality cut. Manual end trimmer. It allows a perfect, clean and high quality cut on all the corners of the board. No other finishing operations are needed. Equipped with twin use blades. For trimming PVC, melamine, Polyester, veneer, etc...
For cutting the excess of PVC, ABS, melamine... tapes on boths side of the straight panels and the excess on circular panels. It provides a clean and exact cut without to damage the panel. It cuts tapes up to 55 mm width and 1 mm thickness or 25 mm width and 3 mm thickness.Its cutting system with two blades allows to cut the tape without effort, even...
Edge milling cutter KF 6 – to mill off edge bands on longitudinal edges and corners on straight and curved workpieces